Use and Care Guide

38
CUT
Use bolts where Wall Angles overlap.
You will need for this page:
Step 14: Continued
Finish weather stripping the roof and cut the
tape just past the end of the roof. Fold end of
tape under roof edge.
7
9
Attach Short Ridge Cap with two (2) bolts and
nuts. DO NOT secure end of Ridge Caps until
Peak Caps are in place.
8
Attach End Panels to the Roof Panel next to it
using one (1) bolt and nut each. Place a strip of
tape over the bolt to seal.
Place strips of tape over bolts to seal.
DO NOT secure end of Ridge Caps
until Peak Caps are in place.
1
On both sides of the building, secure the bottom
of Roof Panels to the Side Wall Angles with
screws. Use bolts and nuts where Wall Angles
overlap.
Continue to apply weather stripping.
(QTY: 24)
(QTY: 8)
Ridge Cap
1
8486
7571
7571
0
• Bolts under Ridge Cap pass thru slots where
the End Roof Panel is overlapped by the Panel
next to it (labeled rib 2 below).
• Bolts that connect Ridge Caps together pass
thru slots where the Center Roof Panel over-
laps the Panel next to it (labeled rib 5 below).
1
2
3
4
5
DO NOT fully tighten Ridge Cap
bolts until you have both Ridge
Cap bolts in place. This will ease assembly.
Bolts must be fully tightened before moving
on to the next page.
38A