Use and Care Guide

Roof Panel

7571

Roof Panel

7743

Weather stripping tape should be applied in one

continuous strip along the length of the roof.

You will need for this page:

(QTY: 4)

(QTY: 32)

DO NOT FASTEN AT

THIS TIME

FASTEN TO NEXT PANEL WITH BOLT AND NUT

FASTEN TO ROOF BEAMS WITH SCREWS

FASTEN TO RIDGE CAP (NEXT TWO PAGES)

Step 14: Roof Assembly

Cut four (4) strips of weather stripping 2” (5,1

cm) long from the roll of weather stripping

tape and put aside for later use. Begin weather

stripping the roof ridge. Apply more of the weather

stripping after each additional Panel is installed.

Do not fasten the holes on the lower end of the

Panels. Do not install Panels #9 or #10 yet.

Double check that Panels are installed in the

correct position. The part numbers listed in the Roof

Panel Placement diagram on page 34 must match the

numbers inked on the Panels.

Attach Panels #5 - #8 in the order given in the

diagram on page 34. Use the diagram to the left

while assembling the roof.

Attach Panels #5 - #8 according to the diagram on page 34.

7571

7743

36A