Manualshelf

Installation Guide

ManualsBrandsArrow ManualsMetal Storage ShedsGalvanized Steel Storage Shed (Common: 10-ft x 12-ft; Interior Dimensions: 9.85-ft x 11.71-ft)
31323334353637383940
6
Step 13: Roof Assembly
(QTY: 16)
34
34BJ
You will need for this page:
67545
Weather
Stripping
1
9086
Right Roof
Panel
1
9087
Left Roof
Panel
1
Work one corner at a time. Be sure
to fi nish a corner before moving on to
the next one.
Continue fastening Roof Panel to Gable and Lower Roof
Beam using six (6) bolts and nuts and four (4) screws. Do not
fasten to Side Wall Angle at this time.
3
Attach Back Right Roof Panel to Top Roof Beam only using
four (4) screws.
1
While installing Roof Panels use Weather
Stripping Tape to seal roof ridge.
5
(QTY: 12)
9086
9087
Back
Front
Weather Stripping Tape
should be applied in a
continuous strip along
the length of the roof.
Remove Edge Trim from the Left Gable under the Roof
Panel.
2
Install Back Left Roof Panel.
4
Follow the fastener
sequence shown for
proper alignment.
2
1
3
4
5
6
7
8
9
10
11
12
13
Washer
Bolt
Nut
GABLE
An Awl may be used to help
align holes that are only slightly
misaligned. Take care not to bend
or warp the metal, and always practice
proper tool safety.
14