Installation Guide

22
Place washers on all bolts and screws used
on painted parts.
Wall Panel
2
6515
Front Panel
2
9373
Corner Panel
4
6514
(QTY: 38)
(QTY: 4)
You will need for this page:
Step 6: Corners
Working one Corner at a time, attach the Corners to the
Floor Frame in the position shown using four (4) screws per
Corner. The widest part of each Corner must be placed along
the side of the building for all four (4) Corners.
1
22BJ
FRONT
6514
6514
6514 6514
6515 6515
9373
9373
6514
9373
Wall Panels ALWAYS attach to the Floor Frames with
screws in the manner shown above. Rest the panel on
the Floor Frame and the holes in the Panel should line up
with the holes in the frame.
Use one person to support the Corner while
another secures the Panels. Do not leave the
Corner unsupported until it is secure.
Be cautious when
maneuvering and placing
Panels. Once Panels
begin to go up it is
important to be able to
fi nish in a timely manner
to reduce the possibility
of wind damage to your
building.
Bolt
FRONT
Leave these holes open.
9373
9373
6514
6514
6514
6514
6515
6515
Double check the part numbers
indicated on the Panels. Front Wall
Panels (9373) must be installed along
front of building and Wall Panels
(6515) must be installed along rear of
building.
Attach the Front Wall Panels to the front Corner Panels with
a screw in the top and bottom of each Panel and a bolt and nut
through the middle hole of each Panel. Place screws through
all holes along the bottom of the Panels, but leave the hole closest to
the Ramp open in each Front Panel as shown.
2
Attach the Wall Panels to the rear Corner Panels with a screw
in the top and bottom of each Panel and a bolt and nut through
the middle hole of each Panel. Place screws through all holes
along the bottom of the Panels.
3