Specifications

MAINTENANCE
550 Gas/LPG 330650 (9--00)
68
A
B
C
D
E
F
G
H
I
00196
REAR SQ UEEG EE
A. Adjuster F. Frame
B. Spring Guide G. Rear Blade
C. Front Band H. Back -Up Strip
D. Front Blade I. Band
E. Band Clamp
TO ADJUST REAR SQUEEGEE
1. Lower the rear squeegee and drive the
machine slowly forward to observe the
squeegee roll-out. Adjust the squeegee
roller height adjustment stud or add or
remove washers from the caster to get an
even roll-out. The top nut acts as a locknut.
The nut just under the squeegee frame is
the adjusting nut. Loosen the locking nut
and turn the adjusting nut clockwise to
increase down pressure, or
counterclockwise to decrease pressure.
T ighten the locknut after adjusting the
adjusting nut.
2. Lower the rear squeegee and drive the
machine slowly forward to observe the tips
of the squeegee.
a. If both tips are too low, tighten both
eyebolts which increases the down
pressure on the back side of the
squeegee frame to lift both tips.
b. If both tips are too high, loosen both
eyebolts which decreases the down
pressure on the back side of the
squeegee frame to lower both tips.
c. If just one tip is too low, loosen the
eyebolt on the side that is too low. If the
tip is still too low, tighten the eyebolt on
the opposite side.
d. If just one tip is too high, tighten the
eyebolt on the side that is too high. If
the tip is still too high, loosen the
eyebolt on the opposite side.
NOTE: The number of washers on the squeegee
tip casters may need to be changed to properly
adjust the squeegee tips.
Home
Find...
Go To..