Specifications

MAINTENANCE
65
550 Gas/LPG 330650 (9--00)
TO REPLACE REAR SQUEEGEE BLADES
1. Stop the engine and set the parking brake.
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, And Turn
Off Machine.
2. Open the band clamp and remove all parts.
3. Place the new squeegee blade over the pins
on the frame.
4. Next, fit the two back-up strips on the pins.
Inner strip down, outer strip up.
5. Position the retaining band in place and
engage the clamp.
6. The front blade is replaced in the same
manner , except that backup strips are not
used.
7. Adjust the squeegee clamp so that there is
adequate pressure to hold the squeegees in
place. The squeegee blades should be held
so they cannot be pulled from between the
locating pins. After proper adjustment is
made, lock each adjusting screw with a jam
nut.
A
C
B
00290
REAR SQ UEEG EE
A. Band
B. Blade and Back-Up Strips on Pins
C. Clamp
B
F
A
C
B
D
E
00151
REAR SQ UEEG EE CROSS-SECTION
A. Squeegee Frame
B. Band
C. Outer Back-Up Strip
D. Inner Back-Up Strip
E. Rear Blade
F. Front Blade
NOTE: Install back-up strips with outer strip up,
inner strip down.
TO FACTORY ADJUST REAR SQUEEGEE
NOTE: The solution tank must be full, and the
tires must be correctly inflated to properly adjust
the rear squeegee.
1. LINKAGE PIVOTS
Check the squeegee linkage pivot points
and, if necessary, tighten the locknuts on
each bearing joint in the linkage. Tighten
each locknut until the joint is just short of
locking up. The linkage must be snug, but
still free enough to rotate the linkage by
hand.
2. SQUEEGEE LIFT CYLINDER
The squeegee lift cylinder rod end should be
adjusted so there is 5.50 +
0.12 in
(140 +
3 mm) between the cylinder rod hole
and the rod end hole should be 6.00 +
0.12
in (150 +
3mm).
B
A
01725
SQUEEGEE LIFT CYLINDER
A. Cylinder
B. Adjustment Length
Home
Find...
Go To..