Specifications

MAINTENANCE
550 Gas/LPG 330650 (9--00)
34
SCRUB HEAD HINGES
There are two grease fitting which are used to
lubricate the scrub head hinges. One grease
fitting is located on the underside of each of the
hinges. Apply grease to these fittings after every
50 hours of operation. Use a Lubriplate EMB
grease (TENNANT Part No. 01433--1).
B
A
03792
SCRUB HEAD HINGE
A. Scrub Head
B. Grease Fitting
REAR SQUEEGEE CASTERS
Lubricate the rear squeegee casters after every
50 hours of operation. Use Lubriplate EMB grease
(TENNANT Part No. 01433--1).
SCRUB BRUSH IDLER PLUGS
There are two grease fittings which are used to
lubricate the brush idler plugs. They are located in
the center of each idler plug and are covered with
plastic caps. Snap the caps open to apply grease
to the fittings. Use a Lubriplate EMB grease
(TENNANT Part No. 01433--1). Wipe off all
excess grease and replace the plastic cap. Apply
grease to the fittings after every 50 hours of
operation.
A
B
03793
BRUSH IDLER PLUG
A. Idler Arm
B. Grease Fitting
REAR WHEELS
The rear wheels have automotive-type bearings.
Repack the bearings with automotive-type wheel
bearing grease after every 2000 hours of
operation.
Home
Find...
Go To..