Specifications

OPERATION
15
550 Gas/LPG 330650 (2--06)
OPERATING LIGHTS SWITCH (OPTION)
The operating lights switch is present on
machines with the operating lights option. It
controls the headlights, taillights, and the brush
spot light. Flip the switch toggle upward to turn
the lights on. Flip the switch toggle down to turn
the lights off.
ROTATING LIGHT SWITCH (OPTION)
The rotating light switch is present on machines
with the rotating light switch option. Flip the switch
toggle up to turn the light on. Flip the switch
toggle down to turn light off.
HAZARD LIGHT SWITCH (OPTION)
The hazard light switch is present on machines
with the hazard light option. Flip the switch toggle
up to turn the light on. Flip the switch toggle down
to turn the light off.
FUEL LEVEL GAUGE
The fuel level gauge is present on all gasoline
powered machines. The gauge indicates how
much fuel is left in the fuel tank.
NOTE: Do not use leaded fuels. The use of
leaded fuels will cause permanent damage to the
system’s oxygen sensor and catalytic convertor
PANEL LAMP (OPTION)
The panel lamp is present on machines with the
operating lights option. The lamp lights whenever
the operating lights switch toggle is flipped up to
turn on the operating lights.
TANK DRAIN LAMP (OPTION)
The tank drain lamp lights when the recovery tank
is nearly full. The machine operator can then plan
to return to a draining location.
SCRUB BRUSH PRESSURE LAMP (OPTION)
The scrub brush pressure lamp option lights when
scrub brush down pressure is excessive, which
may cause the brushes to stall. The operator
should then check the brush position adjustment.
NOTE: This information holds true only after the
hydraulic fluid has warmed up (about 10 to 15
minutes). If the light comes on after the oil is
warm, the cause may be operating on a rough
floor-use “restricted” brush down pressure.
ENGINE HOUR METER
The hour meter records the number of hours the
machine has been operated. This information is
useful in determining when to service the
machine.
FUSES (For machines below serial number
007006)
Fuses are a one-time circuit protection device
designed to stop the flow of current in the event of
a circuit overload. Never substitute higher value
fuses than those specified in this manual. The
chart below shows the various fuses and the
electrical components they protect.
PROTECTIVE
RATING CIRCUIT
P
R
O
T
E
C
T
I
V
E
DEVICE
R
A
T
I
N
G
C
I
R
C
U
I
T
PROTECTED
Fuse 15 A Auto-Squeegee
Fuse 1A Recovery Tank Level
Lamps
Fuse 1A SRS Tank Level
Lamps
Fuse 15 A Brush Pressure Lamp,
Squeegee Pressure
Lamps
Fuse 20 A Rotating, Hazard
Lights
Fuse 10 A SRS Solution Pump
FUSES (For machines serial number 007006
and above)
Fuses are a one-time circuit protection device
designed to stop the flow of current in the event of
a circuit overload. Never substitute higher value
fuses than those specified in this manual. The
chart below shows the various fuses and the
electrical components they protect.
PROTECTIVE
DEVICE
RATING CIRCUIT
PROTECTED
Fuse--1 5A Key Switch
Fuse--2 20 A Main Power
Fuse--3 15 A Auxilary Power
Fuse--4 15 A Fuel Pump
50 A Alternator (In--line)
Home
Find...
Go To..