Installation Instructions

22
Step 9
C22
● Parts Needed For ●
Right Roof Panel
●●
●●
● 6442 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner of
the building. Each screw and bolt in
the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers and place them on the
ground alongside the building in their
proper positions.
2 Position the right roof panel at the
back right corner and fasten to the
gable and roof beam using screws
and bolts as shown. Do not fasten the
lower end of the panel to the side wall
angle at this time.
Hint: Follow the fastener
sequence shown, for proper
alignment.
6442 Right Roof Panel
FRONT
Washer
Bolt
Gable
STEP
2
STEP
1
Nut
1
2
3
4
5
6
7
6443
2
4
1
3
FRONT
64436442
6442
8