Installation Instructions

● Parts Needed For ●
Right/Left Roof Panels
Step 16
BE27
27
2
●●
●●
● 9878 Right Roof Panel (1)
●●
●●
● 9879 Left Roof Panel (1)
9879 Left Roof Panel
STEP
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the right side of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align.
1 Locate the roof panels and find the
right roof panel part number 9878.
2 Position a right roof panel at the
right side and fasten to the gable,
header and roof beam and rear wall
angle using screws and bolts with
nuts as shown.
Note: Tab of roof beam is fastened
between roof panel and gable using
the center hole.
3 Install the left roof panel 9879 on
the left side in the position shown
below.
3
STEP
Screws To
Rear Wall
Angle
Bolts To
Gable
Fasten At
Overlap With
Bolt (Later)
Screws To
Roof Beam
Screws To
Header
Nut
Washer
Bolt
Gable
Roof Beam
9878 Right Roof Panel
FRONT