Installation Instructions

22
● Parts Needed For ●
Corners/Gables
Step 11
BE22
2
STEP
9872
TOP VIEW
Wide Side
SIDE
9891
9870
Panels rest on
frame as shown
9874
4
Attach panels with extra
holes facing up.
1 Position right & left front corner
panels at the corners of the floor
frame as shown. The widest part of
each corner panel must be placed
along the front of the building. Fasten
the corner panels to the floor frame
with four screws, where shown.
Support the corner panel with a step
ladder until next panel is fastened.
2 Attach the right & left rear corner
panels to the rear corners, as shown.
NOTE
Be careful to install the correct
panel in each position as shown
3 Fasten wall panels 9874 to the
sides of building using four screws
into side floor frame. The crimped rib
should go under the rib of adjacent
panel. Fasten overlapping rib using
two screws and a bolt with nut.
4 Fasten the right & left gables
across the top of the side panels
using five screws on each gable.
5 Double-check the part numbers of
the wall panels, before proceeding.
Each screw and bolt in the wall
requires a washer.
NOTE
The remainder of the building assembly
requires many hours. Do not continue
beyond this point if you do not have
enough time to complete the assembly
today. A partially assembled building can
be severely damaged by light winds.
●●
●●
● 9870 Right Front Corner Panel (1)
●●
●●
● 9871 Left Front Corner Panel (1)
●●
●●
● 9872 Right Rear Corner Panel (1)
● ●
● ●
● 9873 Left Rear Corner Panel (1)
● ●
● ●
● 9874 Wall Panel (2)
● ●
● ●
● 9890 Right Gable (1)
● ●
● ●
● 9891 Left Gable (1)
SIDE
Narrow
Side
REAR
FRONT
3
STEP
1
STEP
STEP
9873
Washer
Crimped Rib
Underneath
9890
9871
9874
The floor frame must be square
and level or holes will not align.
CORRECT INCORRECT