Installation Instructions

● Parts Needed For ●
Right Door Assembly
Step 9
QR20
20
STEP
1
10183
6
STEP
The steps on this page tell how to
assemble the right door. Proceed as
follows:
1 Position hinges on side of right
door panel as shown and fasten with
7/16" (11 mm) flat head bolts outside
and #6 hex nuts inside.
2 Slip foam board under lip of door,
away from hinges, foil facing out-
ward. See caution. Hold the vertical
door brace against the long edge of
the foam board inside the door and
fasten to door using five bolts and
nuts.
3 Position astragal to door, as shown,
and fasten to side of door using six
screws.
4 Cover ends of door panel with
door braces. Edge of door panel
slides into brace. Fasten braces to
door using two screws on each brace.
5 Fasten door latch brace to door
and astragal using four screws. Us-
ing an awl, ice pick or nail, push
holes through foam board at the
handle holes. Attach locking handle
to door using 7/8" (22 mm) bolts.
6 Attach latch by inserting onto
square shaft of handle.
7 Set the door aside for later use.
●●
●●
● 9905 Door Brace (2)
●●
●●
● 9940 Right Door (1)
●●
●●
●10183 Door Latch Brace (1)
●●
●●
●10176 Astragal (1)
●●
●●
● 67734 Foam Board (1)
● ●
● ●
● 9944 Vertical Door Brace (1)
● ●
● ●
● 66054 Latch - Attic Door (1)
Screw
5
STEP
2
STEP
4
STEP
67734
Foil Side
9905
9944
Screw
10176
9905
Hinge
Flat Head Bolt
7/16" (11 mm)
9944
9940
10176
67734
9940
CAUTION:
SHARP EDGE
3
STEP
Hinge