Installation Instructions

● Parts Needed For ●
Roof Beam/Rear
Wall Angle Assembly
Step 8
BE19
19
STEP
1
9885
2
STEP
●●
●●
● 9885 Roof Beam (2)
●●
●●
● 9883 Rear Wall Angle (2)
Rear Wall Angle Assembly
Roof Beam Assembly
The main frame pieces reinforce the
walls and roof. These pieces will later
be installed in the center of the roof
and at the top edge of the rear wall.
Proceed as follows:
1 Overlap the roof beam pieces as
shown in the figure (large hole on
top) and fasten the two pieces to-
gether with four bolts and nuts where
shown.
2 Overlap the rear wall angle pieces
as shown in the figure and fasten
them together with four bolts and nuts
where shown.
3 Set the assemblies aside. You will
use them later.
9885
9883
9883
95 7/8"
243,5 cm
94"
238,8 cm