Installation Guide

Attach Floor Frame Assembly

PM07

6 Do not fasten decking material at this time!

NOTE: FLOOR FRAME MUST BE LEVEL AND

SQUARE BEFORE PROCEEDING!

If you are using decking material, complete the

floor frame assembly for the storage building as

shown in the assembly instructions found in the

building carton. Position floor frame assembly on

base kit, equal distance on the sides, front and

rear. Disregard statement in building instructions

and anchor front and rear floor frames at dimension

shown to side channels and side floor frames to

cross channels using bolts and nuts.

If you are using the base kit as a finished form to pour

concrete, see next page. Pour concrete first, then

attach the floor frame assembly using concrete an-

chor bolts, available at your local building supply

store.

USE SLOT

2" 5,1 cm

10x12, 10x13 or 10x14

2" 5,1 cm

Model ES1014

SIDES & REAR

NOTE: PICK UP COMPLETED KIT TO ATTACH

NUTS TO BOLTS AT THESE TWO LOCATIONS.

* If there are no anchor holes in floor frames, or they do not line up:

Assemble the base kit to match the floor frames, and drill 1/4" (6 mm)

dia. holes at the cross members for attachment with bolts and nuts

provided.