Warranty

The rear  oor frame is made up of 2
pieces. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. The
illustration below shows the proper
overall length for the rear.
1 Overlap right and left rear frames,
align holes, and fasten using 8 bolts
and nuts. Make 3 assemblies. Use
1 assembly for this step.
Step 4
BW16
 Parts Needed For 
Floor Frame Assembly
12x10 (3,7 m x 3,0 m)
 8532 Right Rear Frame (1)
 8531 Left Rear Frame (1)
 7837 Side Frame (2)
 7834 Right Front Frame (1)
 7835 Left Front Frame (1)
 7517 Lower Door Track (1)
 7560 Ramp (1)
#10-32 Square Nut
#10-32x1/4" (6 mm)
Bolt
7837
8531
4 Select location of side door
on either side, toward the rear of
building. Install lower door track
and ramp, notch toward outside,
using 1/4" (6 mm) bolts and nuts,
as shown. See Step 12 for Rear
Door Installation.
2 Position  oor frames as shown
and fasten at each corner using 2
bolts through the bottom and nuts
on top.
3 Measure the  oor frame diago-
nally. When the diagonal measure-
ments are equal, the  oor frame is
square.
7834
Position with small holes
toward outside of building
7835
FRONT
7837
7517
7560
8532
Level
#10-32x7/16" (11 mm) Bolt
SIDE
REAR
Slot
Notch toward outside
of building
Side Frame
7517
7560
8531
Rear Frame 140 7/8" 357,8 cm
8532
STEP
1
STEP
4
STEP
3
STEP
2
NOTE
Do not fasten the  oor frames to
your foundation at this time. You
will anchor the building after it is
erected.
The  oor frame must be square
and level or holes will not align.
18