Use and Care Manual

Step 8
BY21
● Parts Needed For ●
Wall Panels
●●
●●
● 8995 Wall Panel (2)
●●
●●
● 9363 Wall Panel (2)
●●
●●
● 9364 Wall Panel (4)
The wall panels come in two widths.
Each wall panel has a crimped rib on
one side. The crimped rib should go
under the rib of the panel that follows
it.
1 Locate all of the wall panels and
set each one alongside the building.
2 Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and deter-
mining if the holes line up with the
holes in the frame.
3 Fasten the wall panels at the top
and bottom with screws.
4 Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with 2 screws.
5 When you have attached all wall
panels in the correct positions, the
building will look like this.
21
STEP
1
9364
STEP
2
9364
STEP
4
Bolt and nut
does not go thru
wall channel
at overlap
STEP
3
Crimped Rib
Underneath
STEP
5
Use bolts and
nuts thru wall
angle overlaps
at the top of
panel at sides
and rear.
8995
9364
9364
8995
Detail Showing
Center of Panel Screwed
to Wall Channel
9363
9363
Panels rest on
frame as shown