Use and Care Manual

1 Position the rear corner panels at
the rear corners, as shown. The wid-
est part of each rear corner panel
must be placed along the rear of the
building. Attach the corner panels to
the floor frame with 4 screws.
2 Position a front corner panel at
the corner of the floor frame as sown.
The widest part of each front corner
panel must be placed along the front
of the building. A small gap will exist
between front corner panel and ramp.
Fasten the corner panel to the floor
frame with 3 screws.
NOTE
Be careful to install the correct
panel in each position as shown
●●
●●
● 9380 Front Wall Panel (2)
●●
●●
● 9384 Rear Corner Panel (2)
Step 6
BY19
● Parts Needed For ●
Corners
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
3 Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must be square
and level or holes will not align.
19
STEP
1
9380
9384
REAR
FRONT
9380
SIDE
TOP VIEW
Wide Side
STEP
3
STEP
2
SIDE
9384
Narrow Side
Washer
Panels rest on
frame as show
9380
9384
9380
9384