Use and Care Manual

16
The roof beams join the 2 gables and
support the roof panels. The roof as-
sembly is made up of 4 pieces over-
lapped back to back at the center.
Hint: These pieces are force-fitted,
so you may have to press hard to join
them together.
1 Place the end of one roof beam
inside a second roof beam so that the
6 holes (4 holes if 2" beam) in each
piece align. Make 2 sets of 4" roof
beams and 4 sets of 2" roof beams by
repeating this procedure.
Do not insert bolts yet.
2 Take 2 of the pressed-together 4"
roof beams and join them as shown
to form the main roof beam assembly.
Hold the assembly together and fas-
ten with 14 bolts and nuts.
Make 1 assembly.
3 Make 2 of the press-together 2"
roof beams and join them as shown
to form the roof beam assembly. Hold
the assembly together and fasten with
12 bolts and nuts. Make 2 assem-
blies.
4 Set these pieces
aside for later assembly.
Step 3
BY16
● Parts Needed For ●
Roof Beam Assemblies
●●
●●
● 10470 Roof Beam (4)
●●
●●
● 10471 Roof Beam (8)
STEP
1
Assembled
91 7/8" 2,3m
2" Roof Beam Assembly
at Outer Side of Roof
End
View
91 7/8"
2,3m
91 7/8"
2,3m
4" Roof Beam Assembly at Peak
STEP
2
STEP
3
2"
10471
Make two sets 4"
Make four sets 2"
4"
10470
2"
10471
91 7/8" 2,3m
4"
10470