Use and Care Manual

Step 2
BY15
15
● Parts Needed For ●
Frame Assemblies
The main frame pieces reinforce the
walls. These pieces will later be in-
stalled in the center and at the top
edge of the side walls and the rear
wall. Proceed as follows:
1 Overlap the rear wall channel
pieces as shown in the figure and
fasten the 2 pieces together with 1
bolt in the center hole
(3 holes will
align).
2 Make 2 side wall channels by
overlapping the side wall channel
pieces as shown. Fasten each set
together with 1 bolt in the center hole
of each set.
3 Overlap the rear wall angle
pieces as shown in the figure and
fasten them together with 1 bolt in the
center hole.
4 Make 2 side wall angles by over-
lapping the side wall angle pieces as
shown. Fasten each set together with
1 bolt in the center hole.
5 Set the assemblies aside. You will
use them later.
●●
●●
● 6615 Rear Wall Angle (2)
●●
●●
● 9924 Rear Wall Channel (2)
●●
●●
● 9990 Side Wall Channel (4)
● ●
● ●
● 9991 Side Wall Angle (4)
STEP
1
94 5/8" 2,4m
9924
STEP
2
9924
9990
Side Wall Channels
89 7/8" 2,3m
9990
Rear Wall Angle
94 5/8" 2,4m
6615
6615
9991
9991
Side Wall Angles
89 7/8" 2,3m
STEP
3
4
Rear Wall Channel
94 5/8" 2,4m
Side Wall Channels
89 7/8" 2,3m
Side Wall Angles
89 7/8" 2,3m
Rear Wall Angle
94 5/8" 2,4m
STEP
5
STEP
Rear Wall Channel