Use and Care Manual

The front floor frame is made up of 3
pieces. The side floor frames and the
rear floor frame are made up of 2
pieces. The holes in these pieces
will align when the pieces are posi-
tioned with correct amount of over-
lap. The illustrations below show the
proper overall length for the sides,
rear and front. Proceed as follows:
1 Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the 2
front floor frames. Join the frames by
inserting 8 screws.
2 Overlap the side floor frames and
the rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned with cor-
rect amount of overlap. See the illus-
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting 4/5 bolts
into each frame set as shown.
3 Double check the length of each
and set these pieces aside for later
use.
Step 1
BY14
● Parts Needed For ●
Floor Frame Assemblies
●●
●●
● 8941 Ramp (1)
●●
●●
● 9379 Front Floor Frame (2)
●●
●●
● 9377 Rear Floor Frame (2)
●●
●●
● 9989 Side Floor Frame (4)
14
9379
STEP
1
8941
9379
DRAIN HOLES FACE
OUTSIDE
Front Floor
Frame Assembly
95 7/8" 2,4m
9377
9989
9379
8941
9379
9989
9989
Side Floor Frame 91 1/8" 2,3m
9377 9377
Rear Floor Frame 95 7/8"
2,4m
STEP
2
STEP
3
91 1/8" 2,3m
91 1/8" 2,3m
95 7/8" 2,4m
Front & Rear
95 7/8" 2,4m