Specifications

Editing Text with the Message Composition Tool
If your operating system version is English
and the message text you are editing is
English then you may use your keyboard to
type a line of text.
If the text of the message is in a language
other than English, you can double-click
characters, including spaces, in the
character matrix to add to the message line
below. You can also drag a character from
the character matrix to the message field.
Click the Clear button to delete the text in
the message field at the bottom of the
window. Click Undo Last to delete the
final character of the line of text.
To move text from the Message
Composition Tool to the Edit Messages
window, drag the text while holding down
the control key on your keyboard.
Message Composition Tool window
Dragging Text
Use the following steps to create and drag lines of text:
1 Move the Message Composition Tool window to the right to
show the Edit Messages window.
2 Move the cursor over the text in the bottom field of the Message
Composition Tool window that you want to drag.
3 Press and hold down the Ctrl key on your keyboard.
4 Press and hold down the left mouse button.
5 Move the cursor to the field in the Edit Messages window where
you want the text to appear. The text is dragged along with the
cursor. The fields in the Edit Messages window correspond to
lines of text displayed to the patron.
6 Release the mouse button and the Ctrl key. This places the text
in the field. Any text that appeared in the field before is
overwritten.
7 Continue editing and dragging text using the procedures on this
page until your message is complete.
8 Click OK in the Edit Messages window when complete.
9 Click Close in the Message Screen Editor window.
78-8123-7438-3 Rev B, 060-A
20