Specifications

SelfCheck™ Manager Procedures
This section contains common procedures for configuring and
adjusting the SelfCheck Manager.
Mode Procedures
Use the following procedures to set the SelfCheck system in
different modes of operation:
Mode menu
SelfCheck Mode
Select SelfCheck from the Modes menu. This starts the SelfCheck
program while leaving the SelfCheck Manager active. You can use
this to observe changes to the SelfCheck program while adjusting
the configuration. Pressing the escape key (Esc) on the keyboard
will to return the system to the SelfCheck Manager.
Out of Service Mode
Select Out of Service from the Modes menu. This sets the
SelfCheck system in the Out of service mode and shows the out of
service graphic on the screen. When the Out of Service graphic is
displayed, pressing the escape key (Esc) on the keyboard will to
return the system to the SelfCheck Manager.
Demonstration Mode
Select Demonstration from the Modes menu. Putting the
SelfCheck system in the Demonstration mode allows check out of
items for training or demonstration purposes. While in the
demonstration mode the SelfCheck system does not communicate
with any other system.
78-8123-7438-3 Rev B, 060-A
17