Outdoor Storage User Manual

Step 6
® Parts Needed For ®
Corners
® 8995 Wall Panel (2)
• 9372 Front Wall Panel (2)
Q 9156 Corner Panel (4)
UNI9
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
"1 Position a corner panel at the
corner of the floor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all four corners. Fasten
Narrow
Wide Side
the corner panel to the floor frame
with four screws.
8995
Support the corner panel with a step
ladder until a wall panel is attached.
2 Attach the front wall panels to the
front corner panels, as shown. A small
gap will exist between front wall panel
and ramp.
3 Attach the wall panels to the rear
corner panels, as shown.
4. Double-check the part numbers of
the wall panels, before proceeding.
IThe floor frame must be square I
9372
8995 Crimped Rib
8995 Underneath
Washer
#8-32 Hex Nut
9372
Panels rest on
frame as shown
#8Ax5/16"Sclew
19