Outdoor Storage User Manual

Step 3
® Parts Needed For O
Roof Beam Assemblies
• 9294 Right Roof Beam (4)
• 9295 Left Roof Beam (4)
S_6
The roof beams join the two gables
and support the roof panels. The main
roof beam is made up of four pieces
overlapped, back to back at the cen-
ter. The left and right roof beam as-
semblies are made up of two pieces.
9295 __,
Hint: These pieces are force-fitted, How.To Hentify Left and "_'_... _'_ Right
so you may have to press hard to join Right Roof Beams "-_.:...._.... o;_
them together.
"1 The figu re shows how to identify a 1137/16"
2,9m
left and a right roof beam. As you
will note, the difference is only which
end of each beam has the six holes
for joining the beams at the center.
2 Place the end of a right roof beam
inside a left roof beam so that the six
holes in each piece align. Make four
sets of roof beams by repeating this
procedu re. Do not insert bolts yet.
3 Take two of the pressed-together
roof beams and join them as shown
to form the main roof beam assembly.
Hold the assembly together and fas-
ten with 14 bolts and nuts.
4 Fasten the other two pressed-
together roof beams with 8 bolts to
make the left and right roof beam
assemblies.
5 Set these pieces aside for later
6
1137/16"
2,9m
Single Beam
Assembly
at Side of Roof
assembly.
16
Main Roof Beam
1137/16"
Doubled Beam Assembly at Peak 2,9m
1137/16"
2,9m