Outdoor Storage User Manual

45
Roll-Up-DoorRoll-Up-Door
Roll-Up-DoorRoll-Up-Door
Roll-Up-Door
Step 33Step 33
Step 33Step 33
Step 33
BW45
STEP
22
22
2
STEP
11
11
1
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION:
FROM THIS POINT ON, BE SUREFROM THIS POINT ON, BE SURE
FROM THIS POINT ON, BE SUREFROM THIS POINT ON, BE SURE
FROM THIS POINT ON, BE SURE
TO USE EXTREME CAUTIONTO USE EXTREME CAUTION
TO USE EXTREME CAUTIONTO USE EXTREME CAUTION
TO USE EXTREME CAUTION
UNTIL THE DOOR IS PROPERLYUNTIL THE DOOR IS PROPERLY
UNTIL THE DOOR IS PROPERLYUNTIL THE DOOR IS PROPERLY
UNTIL THE DOOR IS PROPERLY
SPRUNG AND OPERATINGSPRUNG AND OPERATING
SPRUNG AND OPERATINGSPRUNG AND OPERATING
SPRUNG AND OPERATING
11
11
1Attach
"S" hooks "S" hooks
"S" hooks "S" hooks
"S" hooks to both
springs.springs.
springs.springs.
springs.
Fasten
sheave sheave
sheave sheave
sheave and
spring clevis spring clevis
spring clevis spring clevis
spring clevis to
opposite ends of springs using a 3/8-
16x1 1/2" hex head bolt and 3/8 nut.
Attach spring assemblies to spring
support brackets.
22
22
2Carefully raise the door to a fully
open position and prop. Make sure
the door is level in the opening. Slip
the keyed end of the
keyed cablekeyed cable
keyed cablekeyed cable
keyed cable
over the studs of the bottom brackets.
Thread cable over front sheave,
around spring sheave and attach end
to
cable lacer. cable lacer.
cable lacer. cable lacer.
cable lacer. Attach cable lacer
with "S" hook in a convenient hole in
horizontal track angle, keeping equal
tension on both springs, so that door
hangs level. Once cable is installed,
remove prop and lower door.
33
33
3Adjust vertical tracks so rollers seat
in "U" of track and bottom rollers fit
snug against bottom brackets, but
not too tight, so rollers will operate
freely. When complete, tighten all
track bolts.
44
44
4Adjust striker plates for proper en-
gagement with the latches. Adjust
the top fixture up or down and tighten
the screws to hold the third door panel
against the lintel.
NOTENOTE
NOTENOTE
NOTE
Recheck all door fasteners and
hardware to be sure that each
fastener is tight and secure.
CHECKCHECK
CHECKCHECK
CHECK
Be sure that the lift cables do not rub and/or the rollers do not
bind in the track when door is opened or closed. Recheck the
springs to be sure that there is equal tension on both springs. This
is extremely important for proper door operation.
ADJUSTADJUST
ADJUSTADJUST
ADJUST
Springs by changing location of "S" hooks to another hole on
support angle of the horizontal track.