VORTEKS 4X4 3S BLX Stadium Truck Manual

WWW.ARRMA-RC.COM
Variable Setting > 1 2 3 4 5 6 7
1 Low Voltage Cut-O󰀨 Threshold
LIPO NIMH
2 Punch Setting
Level 1 Level 2 Level 3 Level 4 Level 5
3 Brake Strength
25% 37.5% 50% 62.5% 75% 87.5% 100%
4 Running Mode
Fwd/Brk/Rev Fwd/Brk
5 Motor Rotation Normal
(CCW)
Reverse
(CW)
6 BEC Voltage
6.0v 7.4v
If the ESC temperature exceeds 125 degrees Celsius/257 degrees Fahrenheit, the ESC will
enter temperature protection mode and the green status LED will blink. Once the ESC has
cooled down it will resume normal operation after it has been turned o󰀨 and back on again.
Temperature Protection
ESC Tuning Options
The brushless ESC is setup for use straight from the factory, if you want to alter the settings for your
track or driving style please see the table and steps below:
Factory Reset
To reset the ESC to factory default settings, connect a battery, turn the transmitter on and then turn
the car on. Press and hold the set button for 5 seconds and release. The Red and Green lights will
ash simultaneously to show you have reset. Switch the ESC o󰀨 and factory reset is complete.
To alter ESC settings
If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Battery Modes
Power on the
transmitter.
Connect battery
to the esc and
switch on the
esc.
Hold set
key for one
second.
Green led
ashes.
To reset all programming items, press and
hold the set button for ve seconds.
Release the set
button to enter
programming.
Press and
release the
set button.
The number of
times the green
led ashes equals
the programming
item number.
Turn o󰀨 the esc to quit programming mode or to enter
another programming item.
Hold the set button
for three seconds
to select the
programming item.
The number of times the
red led ashes equals the
option number (within the
programming item).
Press and hold the set button
for three seconds to save the
selected option.
18