1/10 SENTON 4X4 MEGA Manual
WWW.ARRMA-RC.COM
WWW.ARRMA-RC.COM
Low Voltage Cut Off
ESC Status LED
Battery Mode
Cut-o Voltage
NiMh LiPo
4.5v 6.4v
ESC Specications
Input Voltage 6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v) BEC Output 6.0v/2A Max
LED o: Neutral throttle
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
HEAT-SINK MAY BE HOT AFTER USE
Battery Plug
Setting 'Jumpers'
Power Switch Receiver Plug
(CH2)
Motor Connectors
Heat-sink
If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
Battery Mode: NiMh
Reverse: On
Factory Defaults
Electronic Speed Controller (ESC)
CONTROLLER OFF SECOND
19