1/10 BOOST MEGA 4X2 Instruction Manual
WWW.ARRMA-RC.COM
If the ESC temperature exceeds 105 degrees Celsius, the ESC will enter temperature
protection mode and the LED will blink. Once the ESC has cooled down it will resume
normal operation.
Temperature Protection
ESC Status LED
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A rising tone will sound to confirm
setup. Make sure the transmitter is set to neutral throttle trim if apllicable.
Operational LED
LED blinking slowly: Partial throttle
LED solidly on: Full Forward/Reverse/Brake
Idle Alarm - If no signal is received or the unit is not bound then a short
TROUBLESHOOTING GUIDE
Problem and LED Indi-
cator
Error Mode Possible Causes Solution
Motor won’t operate. LED
pulses.
LVC has been
activated.
Battery voltage is
below the LVC setting.
Verify the battery is charged.
Motor won’t operate.
short single pulses.
The ESC is in
mode.
The ESC is taking too
much load.
cool before resuming operation.
Consider making changes to gear
ratio to reduce load to the ESC.
Standalone ESC
It is possible to use the SLT 40A 2-in-1 ESC with a separate receiver. When used with a separate
receiver the SLT 2-in-1 unit operates as a standalone ESC.
To enable the SLT 2-in-1 unit to be used as a standalone ESC connect the external receiver/bind
socket on the 2-in-1 unit to CH2 on your receiver and connect your servo to CH1 on your receiver.
The 2-in-1 unit will function without the built in receiver and can be used with any transmitter/receiver.
CH1
1. 2.
CH1
CH2
CH2
RX
CH2
ESC
EXT RX
/ CH2
3.
20