Instructions

WWW.ARRMA-RC.COM
No control of
vehicle or short
range
Transmitter batteries are weak or tted incorrectly
Check Indicator Light on transmitter,
see page 20
Servo wires to receiver loose or connected incor-
rectly
Reinstall servo wires to receiver
Transmitter and receiver unit are not 'bound' cor-
rectly
Transmitter and receiver need to be
bound - see page 22
Steering/Throttle
operation
intermittent
ESC has shut down due to overheating
Stop driving and allow ESC or motor
to cool down
Transmitter and receiver unit are not 'bound' cor-
rectly
Check for sources of interference
and re-bind transmitter/receiver - see
page 22
Vehicle wanders
left/right without
steering input
Steering trim setting out Adjust steering trim - see page 21
Damaged steering components
Check components and replace - visit
ARRMA-RC.com for advice
Drivetrain dirty or damaged
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Steering/Throttle
operation
Reversed
Relevant channel of transmitter is reversed
Reverse relevant channel on trans-
mitter - see see page 21 for factory
defaults
Check that the wires from the ESC to the motor are
connected correctly
Reconnect in the correct orientation
(orange to orange, yellow to yellow
and blue to blue) ensuring t is tight; if
not pinch female connector with pliers
Limited steering
angle
Transmitter steering dual-rate set incorrectly
Adjust transmitter dual-rate - see
page 21 for factory defaults
Damaged steering components
Check components and replace - visit
ARRMA-RC.com for advice
25