Instructions

WWW.ARRMA-RC.COM

ESC Specications

Input Voltage

2S-3S LiPo (7.4-11.1v) 50C 5000mAh

Minimum Req. 6-8 Cell NiMh (7.2v-9.6v)

BEC Output 6.0v/4A Max

Throt tle

Setup

Connect batteries, turn on TX and press/hold the set button ‘A’. Turn the switch on

‘B’ and release the set button when the RED light ashes on the ESC.

1. TX in neutral - press set

button (1 Green ash)

2. TX full throttle - press set

button (2 Green ashes)

3. TX full brake - press set

button (3 Green ashes)

4. Switch o󰀨 ESC to complete setup

Only use fully charged LiPo batteries (4.2V per cell) to prevent

battery/ESC damage.

Electronic Speed Controller (ESC)

Battery Plug

WARNING:

Heat sink

may be hot after use.

Receiver Plug (CH2)

Power Switch & Set button

Motor wires x 3

CONTROLLER OFF SECOND