User`s guide

Touchstone® WTM552 Telephony Modem User’s Guide 42
Getting Battery Wireless Ethernet
Safety Started Installation Installation Configuration Configuration Usage Troubleshooting Glossary
Configuring Client IP Filters
Follow these steps to configure client IP filters.
1 Click the Firewall link in the navigation menu, then click Client IP Filters.
The Client IP Filters window appears.
2 Fill in the fields as follows:
a. IP: the beginning and ending address in a range of IP addresses. To
block only one address, use the same address twice.
b. Port: the beginning and ending port in a range of ports. To block only
one port, enter the same port twice.
c. Type: choose one of TCP, UDP, or BOTH.
d. Block Time: choose Always to set up a permanent block, or Block to
specify days and times to block access.
e. Day: choose the beginning and ending day of the week that this block is
effective.
f. Time: choose the beginning and end time of day that this block is effec-
tive.
g. Enable: check this box to activate the block, or clear the check to disable
the block.
3 Click the Save button to save your changes.
4 Proceed to Configuring MAC Address Filtering
.