Installation guide

About this Document ix
Radio Frequency
Emissions and Im-
munity
FCC Declaration of Conformity
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
aresidential installation. Operation is subject to the following twocondi-
tions: (1) this device may not cause harmful interference, and (2) this device
may accept anyinterference that may cause undesired operations.
This equipment generates, uses and can radiate radio frequencyenergy and,
if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment offand on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from that to
which the receiverisconnected.
•Consult the dealer or an experienced radio/TV technician for help.
The FCC advises that anyunauthorized changes or modifications may void
the user’sauthority to operate this equipment. Formore information on FCC
conformity,please contact: ARRIS Group, 3871 Lakefield Drive,Suite 300,
Suwanee, GA 30024.
This product was FCC certified under test conditions that included the use of
the supplied cables between system components. To ensure compliance with
FCC regulation, the user must use these cables and install them properly.
Product Safety
UL listed per UL60950-1.
CE Compliance
This product complies with the provisions of the Electromagnetic Compati-
bility (EMC) Directive (89/336/EEC), the Amending Directive (92/31/EEC),
the LowVoltage Directive (73/23/EEC), and the CE Marking Directive
(93/68/EEC). As such, this product bears the CE marking in accordance with
the above applicable Directive(s).
Acopyofthe Declaration of Conformity may be obtained by contacting:
ARRIS Group, 3871 Lakefield Drive,Suite 300, Suwanee, GA 30024.
TM608 Installation Guide Release 6 Standard 1.0 December 2008