User manual

Installation

IPC1100 Advanced IP Client Video Set-top • Installation and Operations Manual

365-095-24769 x.1 10/13

Be sure you install the media hub before connecting any other set-tops.

• From the labels on the bottom of each device, record the STB MAC address and serial number of

each set-top.

Figure 10 – IPC1100 Set-Top MAC Addresses

During the installation:

1. Connect the home router.

2. Connect the VMS via the home coaxial network.

3. Connect the IP Client via the home coaxial network.

4. Connect the A/V connections for each set-top to the home theater equipment.

After you finish connecting the components:

1. Perform the Operational Check for the Remote Control. Be sure regular and VoD channels display.

2. Optimize the high-definition settings.

Checking the Home Coaxial Network Topology

This section assumes you are networking two or more IPC set-tops. Before you install the ARRIS Whole

Home IP Video Network hardware:

1. Create a table listing:

ο Every room where you plan to install a set-top

ο The signal levels you measured at the RF cable outlets

ο The HFC MAC Address on the label beneath the set-top used in that room

Optionally, you can include information such as the set-top type, serial numbers, and anything else you

or the service provider considers useful.