User manual

Universal Motor Controller UMC-4 – User Manual – V 02/2015 Page 53 of 54
The compliance with the requirements of the European Directives was
proved by the application of the following harmonized standards:
• EN 55022; EN 55103-1; EN 55103-2; EN 301 489-1; EN 301 489-
17; EN 62479; EN 60950-1; DIN EN 50581
FCC Class A Statement:
Note: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
Contains Transceiver module FCC-ID: Y7N-EMIP100
Industry Canada Compliance Statement
Complies with the Canadian ICES-003 Class A specifications.
Cet appareil numérique de la Classe A est conforme à la norme NMB-003
du Canada.
This device complies with RSS 210 of Industry Canada. This Class A
device meets all the requirements of the Canadian interference-causing
equipment regulations.
Cet appareil numérique de la Classe A respecte toutes les exigences du
Réglement sur le matériel brouilleur du Canada.
Contains Transceiver Module IC-ID: 9482A-EMIP100
Please check local regulations for disposal of batteries. The
battery should never be placed in municipal waste. Use a battery
disposal facility if available.