User manual

Universal Motor Controller UMC-4 – User Manual – V 02/2015 Page 35 of 54
Settings Menu
The Settings menu allows users to save the current settings of the UMC-4,
to load some previously saved settings or to load the factory default
settings.
Select the Save Settings menu to save the current settings onto the SD
card (a writable SD card must be inserted in the card slot). The settings file
will be saved in the directory /ARRI/UMC4/settings. If the directory does not
exist, it will be automatically created.
Select Load Settings and navigate to the previously saved settings on the
SD card (normally /ARRI/UMC4/settings). Select the settings file. The
settings in the file will replace the current settings in the UMC-4.
Select Factory Defaults to load the factory defaults into the UMC-4.
Note: The current settings in the UMC-4 will be lost after loading a settings
file!
Note: The current settings in the UMC-4 will be lost after loading the factory
defaults!
Firmware Update Menu
To keep your UMC-4 up-to-date, you may need to update its firmware.
Please check ARRI’s website for the latest firmware packages. To update
the device, proceed as follows:
1. Copy the firmware update package onto an SD card.
2. Insert the SD card in the SD card slot of the UMC-4.
3. Select Menu>System>Firmware Update, and navigate to the
update package on the SD card.
4. Select the package. A list of modules will be shown on the screen.
5. Press UPDATE. A new warning screen will be displayed. Proceed
by simultaneously pressing the two UPDATE buttons. The screen
will blackout and the status LED starts blinking red and green. The
unit is being updated. This can take up to 30 seconds.