User manual

Page 34 of 54 Universal Motor Controller UMC-4 – User Manual – V 02/2015
Date/Time Menu
By selecting the Date/Time menu you can either show the current date and
time on the screen, or set the current date and time of the UMC-4:
Press the SHOW soft button to display the current time.
Press any soft button to return to the menu.
Enter the Set Time/Date submenu to set the current time and date. Use the
arrow soft buttons to navigate through the time and date settings. Press the
OK soft button to save your settings. Press the CANCEL soft button to
abort the setting and return back to the menu.
Network Menu
The network menu includes the following entries:
Show Parameters: All the relevant parameters of the network interface are
shown in this screen.
Configuration Source: Pressing this button toggles between DHCP and
Manual. If DHCP mode is selected, the UMC-4 will search for a DHCP
server on the LAN to provide all the required network parameters. If
Manual mode is selected, then the next menu Set Parameters will become
active and should be used to manually configure the network parameters.
Set Parameters: This menu is accessible only if the menu entry
Configuration Source is set on Manual. You can set here the IP Address,
the Network Mask, the Gateway Address and the DNS address. Use the
right and left arrows to select a specific parameter and the up and down
arrows to modify their values.
Note: The UMC-4 supports Apple’s Bonjour® protocol; its Bonjour name is
similar to “UMC4-####.local”, where “####” stands for the UMC-4 serial
number. For simple setups consisting of a PC and one or more UMC-4
units, connect the PC to the UMC-4 using a standard Ethernet cable. Make
sure that your PC supports Bonjour protocol (e.g. by installing Apple’s
Safari browser) and select in the Bonjour bookmarks, or type the Bonjour
name of the unit you want to access in the browser’s URL edit box. Set the
Configuration Source in UMC-4 to DHCP.