User manual

Universal Motor Controller UMC-4 – User Manual – V 02/2015 Page 15 of 54
Set up the motor mounting side and torque (if applicable) in the Focus, Iris
and Zoom sub-page of the Home screen.
Side refers to the side of the lens the motor is mounted to (on standard
support rods underneath the lens).
Torque refers to the motor torque; a higher value means higher torque.
Connecting to Hand Unit
Set the radio channel on the UMC-4 in the Radio sub-page of the Home
screen. Make sure that the radio power is switched on and that the
selected radio channel is not already in use by another motor controller.
Set the hand unit to the same radio channel (see the hand unit’s user
manual for further instructions). Once connected, the UMC-4 status LED
will turn blue and the number of connected hand units will display on the
UMC-4 Home screen.
Selecting a Lens File
Select a lens table if you want to display lens data on the WCU-4 hand unit,
or use lens mapping to pre-marked focus rings and focus tracking with the
WCU-4 hand unit, or record lens data to SD card:
Go to the Lens sub-page of the Home screen.
Go to Add to Favorites and select the lens you want to use from the list.
Press ADD+USE to use the lens table and add it to your list of favorites.
You are now ready to shoot.