Instruction manual

5.5 Wired setup
The WCU-3 also allows hard-wired operation via the
ARRI LCS-bus. The WCU-3 may be connected to any
supported camera, motor controller or lens motor
through any standard LCS cable.
The “cable“ symbol in the display‘s status line
appears, when an external power supply is detected,
and “
Hardwire“ replaces the radio information.
The radio module shuts-off automatically, regardless of
its channel setting.
Note: The WCU-3‘s battery will NOT be charged through
any external power supply!
22
Setup
The WCU-3 provides two independently controlled
LCS sockets. Do not use -1/-2 and -3 accessory units
within the same LCS chain!