Instruction manual

screws

Installation

4.4 Attaching the

Integrated Capping

Shutter

To prevent stray light from falling on the film during the

interval time, the ARRI Integrated Capping Shutter covers the

film with a thin metal plate. After each exposure the metal

plate is pushed into the film gate and removed immediately

before the next exposure. The metal plate slides into the

ICS-Guide attached to the film gate. To ensure optimum

operation, the plate of the Capping Shutter must be aligned

with the ICS-Guide.

• Switch off the main camera switch and remove the

camera from the power supply.

• Open the camera door and remove the two fastening

screws ➪ photo. Any spacers between the hinge and

the camera housing should on inside the housing.

• Attach the Integrated Capping Shutter door by its hinge

to the camera housing and tighten slightly the two screws.

• Position the Integrated Capping Shutter door so that

there is an even gap to the housing and the door can

be correctly opened and closed.

• Tighten the two screws ➪ photo.

• Open the Integrated Capping Shutter door by approx.

30° and turn the door lock to the shut position.