Instruction manual

11
screws
film gate ICS-
format mask
cover
ICS-guide
modified
film gate
Installation
• Press the film gate locking lever ➪ photo towards the
magazine throat assembly and push the film gate ➪
photo towards the movement block, pressing lightly
on the lower end of the film gate ➪ photo and paying
attention that the film gate does not hit the movement
block.
• Grasp the film gate by the filter holder ➪ photo and
remove it by pulling upwards.
• Pull the filter holder sideways out of the film gate.
• Press the format mask ➪ photo on its side plate
backwards slightly and pull out of the film gate.
The filter holder and the format mask are held in position
by leaf springs. These leaf springs are each held by two
screws to the film gate.
• Entirely remove the screws holding the lower single
leaf spring, leaving the spring in place.
• Place the cover for the film gate openings over the
fastening holes of the leaf spring. The cover will
deform slightly. Then screw in the cover and the leaf
spring with the two screws.