Instruction manual

ARRI WCU-4 User Manual34
IRIS motor not connected, equivalent for ZOOM and FOCUS motor.
IRIS motor connected, but not available for the WCU-4, e.g. control
through another remote unit, equivalent for ZOOM and FOCUS
motor.
IRIS motor status unknown, e.g. during system startup,
equivalent for ZOOM and FOCUS motor.
Zoom motor LOCKed, equivalent for IRIS and FOCUS motor.
Focus motor LIMITs set, equivalent for IRIS and ZOOM motor.
Focus motor WIDEN set.
Focus motor LIMITs combined with WIDEN.
Zoom motor actual speed value (0-100).
CAM information, respond to message or CANCEL.
Critical CAM information, respond to message or CANCEL.
Radio connection active.
Radio connection disabled.
Low battery.
Pre-marked focus ring active, but no lens data available from
camera or UMC-3A.
ATTENTION: Focus control is disabled in this case.
Main Screen Symbols
A.5 Symbols and Screen Messages
Message Description
HW-Info not stored! Insert a SD-card.
License fi le not valid! The license fi le on the SD card does not correspond to the
WCU-4 serial number.
Used path not found! Create a valid folder structure on the SD card like shown
on page 24 (sub-menu Firmware).
Disabled during record Function not available during camera record.
Calibrate lens motors now? Calibrate lens motors - recommended.
In case you are sure that nothing has been changed since
the last calibration, press CANCEL.
Motors calibrating ... Wait until calibration is fi nished.
Screen Messages