Instruction manual

ARRI WCU-4 User Manual 19

Sub-Menu RADIO CHANNEL

ON OFF Enable/disable radio transmission.

UP or

DOWN Change the radio channel.

SET Conﬁ rm the radio channel selection.

Shown setting:

Radio active on channel “1”.

Note:

When selecting a radio channel, please consider potential local legal restrictions of

transmission bands usage.

A list of the WCU-4 transmission frequencies as well as the general FCC certiﬁ cation can be

found in the Electrical Speciﬁ cations section of this manual.

8.4 Menu MENU

A number of user deﬁ nable conﬁ gurations are available in the following sub-

menus. The user has also access to more detailed system information, WCU-4

ﬁ rmware updates and installation of licensed software features.

Sub-Menu CONTROL SETUP

This screen shows an overview of the current WCU-4 control conﬁ guration.

In this menu the WCU-4 lens motor control can be pre-set, but it is not possible to

change the lens motor settings on the camera or the UMC-3A.

If more than one WCU-4 or an additional zoom unit shall control the lens motors at

a time, it is the responsibility of the user to avoid control conﬂ icts within the hand-

units.

STICK Enter the (ZOOM)-STICK setup sub-menu.

SLIDER Enter the SLIDER setup sub-menu.

KNOB Enter the KNOB setup sub-menu.

Shown settings:

CONTROL MATRIX: All motors assigned and enabled.

Focus with knob.

Iris with slider.

Zoom with stick.