Instruction manual

96
Ramping with the ARRIFLEX 435 Advanced
User Defined Ramping:
In user defined ramping the user can set
– the starting frame rate and the starting shutter angle,
– the end frame rate and the end shutter angle,
– and the ramp time
independently of each other.
• Depress key “7” to change to the PROGRAM menu.
• With keys “1” to “6”, activate one of the available
memory areas.
• Depress the “E”-key. The values can now be edited.
• Enter the desired starting frame rate.
If the digits after the decimal point need not be entered,
complete the entry with the “ENTER”-key.
• Enter the desired starting shutter angle.
If the digit after the decimal point needs not be entered,
complete the entry with the “ENTER”-key.
• Enter the desired end frame rate.
If the digits after the decimal point need not be entered,
complete the entry with the “ENTER”-key.
• Enter the desired end shutter angle.
If the digit after the decimal point needs not be entered,
complete the entry with the “ENTER”-key.
• Enter the desired ramp time.
If the digit after the decimal point needs not be entered,
complete the entry with the “ENTER”-key.
• Depress the “SEND”-key to transfer the program to the
camera.
Note: A program previously stored in the camera will
be erased by this process.
Note: The CCU will calculate ramps always for 40f/s
2
.
The camera will do the conversion for HI and
LO rampspeeds internally.
Accessories