Instruction manual

Image Compensation

The viewfinder system is fitted with an automatic image com-

pensation mechanism.

To enable setting a different image position in certain situ-

ations, the viewfinder system is additionally equipped with

a manual image adjustment mechanism.

Manually Adjusting Image Compensation

• Depress the locking key ➪ photo and hold depressed.

• Turn the adjustment knob ➪ photo until the viewfinder

image is in the desired position.

Reactivating Image Compensation

• Turn the adjustment knob ➪ photo until this locks in

position. Do not depress the locking key.

Note: The automatic image compensation locks in two

positions, 180° apart. This allows the image

compensation to be set to provide an upright

image when using a finder extension.

If the viewfinder image is inverted without the finder exten-

sion, the image compensation must be adjusted to the oppo-

site locking position.

Inverting the Image

• Depress the locking key ➪ photo and keep depressed.

• Turn the adjustment knob ➪ photo approx. 30°

• Release the locking key ➪ photo.

• Keep turning the adjustment knob ➪ photo until this

locks in position.

Pivoting the Contrast Filter

To enable a subjective reduction of viewfinder contrast, a

contrast filter (ND 6) can be pivoted into the optical beam

path by means of a lever ➪ photo.

• The lever ➪ photo is brought into the “ON” position

automatically by depressing the locking key ➪ photo.

• For unrestricted viewing, turn the lever ➪ photo back

into the “OFF” position until it locks in.

Optics

lever

adjustment knob

locking key

for contrast filter

locking key