Instruction manual

46
Removing the Magazine
If the film has not run through the camera completely:
• Open the camera door.
• Swing back the movement block just far enough to en-
able the film to be pulled out from between the film gate
and the movement block.
Note: When slowly swinging back the movement block,
a ball catch is noticeable.
• Pull out the film loop sideways from between the move-
ment block and the film gate.
• Bring the loop into the area between the movement block
and the magazine throat assembly ➪ photo.
Ensure that the loop does not get twisted behind
the movement block as otherwise the film could
be damaged when removing the magazine!
• Swing the movement block forwards again and lock.
• Hold the magazine firmly with one hand and pull the
magazine locking lever back with the other.
When pulling away the magazine ensure that
the film does not get damaged!
• Pull the magazine off upwards.
• Replace the cover on the camera opening.
If the entire film has run through the camera:
• Hold the magazine firmly with one hand and pull the
magazine release lever back with the other.
• Pull the magazine off upwards.
• Replace the cover on the camera opening.
Camera Body
film