Instruction manual

• Insert the film through the left slit on the magazine throat

assembly from the inside ➪ photo.

Do not catch the film.

• With your free hand, turn the drive gear counter-clockwise

while carefully pushing the film through until both perfo-

ration holes are picked up simultaneously by the sprockets.

• Keep turning the gear until the film has been transported

through the throat assembly.

• Flip up the hinged locking clip on the feed shaft ➪ photo.

• Place the film roll on the feed shaft, ensuring that the

feed shaft catch engages the slot on the plastic core.

• Press down the hinged locking clip on the feed shaft.

• By turning the drive gear counter-clockwise, transport the

film further until it reaches to the loop length marking

➪ photo.

Ensure that the film is lying flat against the

outside of the magazine housing.

Magazines

roller arms

feed shaft

drive gear loop length markinghinged locking clip