Instruction manual

128
Magazine
Cleaning the Throat Assembly
The throat assembly ➪ photo can be disassembled for
cleaning.
• Loosen the three screws ➪ photo on the throat assembly
cover ➪ photo.
• Remove the holder plate ➪ photo for the loop protector.
• Pull out the throat assembly cover.
• Clean the film running surfaces ➪ photo and guide
rollers ➪ photo with a brush.
• Put the throat assembly cover back in place.
• Replace the holder plate for the loop protector and re-
tighten the throat assembly cover with the three screws.
Setting Friction on the ARRIMAG 120
• Swing both roller arms ➪ photo away from the
winding shafts until they lock in place.
• Unscrew the three screws on the transparent tensioning
plate ➪ photo.
• Remove the plate.
• Place film cores on both winding shafts.
• Place the tension measurement device ➪ photo on
the film core which will not be measured.
• Hang the hook of the measurement device ➪ photo
on the film core which is to be measured.
• Attach the open magazine to the camera.
Maintenance
screws
running surfaces
guide rollers
holder plate