Specifications
2. Status Indicators
Arriflex 435 Quick Guide, 4/99, Page 6
Viewfinder Indicators: Red LED: Asynchronous operation; camera is not running at set fps rate
ASY: Asynchronous operation; camera is not running at set fps rate
END: Camera ran out of film
BAT: Battery too low for the set fps rate
≤130 fps: less than 20.6 V; 130 - 150 fps: less than 24.1 V
Display Indicators: ■■ glows: The display is in mode 1
bat glows: Battery too low for the set fps rate
≤130 fps: less than 20.6 V; 130 - 150 fps: less than 24.1 V
bat flashes: Battery is too ”soft”, voltage will collapse on use
asy glows: Asynchronous operation; camera is not running at set fps rate
asy flashes: Movement and shutter are not synchronous
end glows: Camera ran out of film
fps flashes: Wrong magazine for currently set fps rate
or, if connected, ESU is not getting a valid signal
PROG glows: Internal program is activated
PROG flashes: Internal program cannot be run: out-of-range fps or shutter
values, wrong magazine for programmed fps values, or
battery too low for programmed fps values
R glows: Camera is set to run in reverse
TC glows: Timecode exposure is enabled and timecode is set
TC flashes: Timecode exposure is enabled, but not recording properly
OFF: Lower line: SEL/SET button is pressed & locking slider is locked
OFF: Upper line in mode 7: electronic shutter of 435ES is off
Shutter flashes: See below
Shutter Flashes (435ES):
Shutter flashes: The electronic shutter adjustment feature of the 435ES has been turned off.
Shutter flashes & red LED: If shutter is locked, it should be unlocked.
Shutter flashes & red LED: If shutter is unlocked, the electronic adjustment feature is defective. Turn
electronic adjustment off and set the shutter manually to continue filming.
Display Warnings: The LCD Display will indicate any situations that will prevent running the
camera by changing one or more of its digits into underlines.
0 0 0 0 0
_ 0 0 0 0
ft
fps
Movement block
not locked
No reverse run with 35-3/2C
1000’ (300m) magazine!
1000’ (300m) ARRIMAG
300E not ready
Secondary shutter/movement
monitor triggered or defective.