Specifications

CAC Distribution Box
Power Bridgeplate
Accessory Power Box (APB)
ARRICAM System Guide 33
CAC Distribution Box
The CAC Distribution Box allows more than one accessory to be connected
to the CAC connector at the same time. It connects to the Studio or Lite
CAC connector and provides three CAC connectors. The box is equipped
with a clamp, so it can be attached to a tripod leg, support rod or the
ARRICAM camera handles.
K2.54130.0 CAC Distribution Box
Accessory Power Box (APB)
The Accessory Power Box provides additional power outlets for accessories,
plus a RUN button. Three connectors supply 24V through a standard
RS 3 pin Fisher socket, and two connectors provide 12V through the
old standard 11 pin Fisher socket.
Compatibility: The Accessory Power Box can be mounted in place of
the In-camera Slate Box either directly to the ARRICAM Studio or to
the Lens Data Box of the ARRICAM Lite. Via a 3/8” threaded hole it can
alternatively be attached anywhere on the camera, and even to any other
camera, in which cases it needs to be powered from a separate battery
or through a Y-cable. The 12V and the 24V connectors provide power
only. They do not provide run/stop functionality or a shutter pulse.
K2.54177.0 Accessory Power Box (includes cover)
K2.54191.0 Power Y-Cable KC-62-S
Power Bridgeplate
Bridgeplate for 19 mm rods with two accessory power outlets (Fischer 3-pin).
Compatibility: This bridgeplate fits on both ARRICAM cameras, but does
not fit on any other camera. The Remote Switch RS-4 cannot be used with
the two power outlets, since they do not support the camera run/stop
functionality.
Note: ARRIFLEX Bridgeplates also fit on the ARRICAM cameras.
K2.54011.0 Power Bridgeplate
W ork Light
The lamp is mounted on a goose neck and can be used e.g. to illuminate
the lens barrel in low-light conditions or to facilitate threading the film.
It operates on 24V.
Compatibility: Fits on Studio and Lite cameras. Uses the same LEMO
Mini Coax connector as the heated eyepiece.
K2.54022.0 Work Light
Work Light
09 / 2003