Specifications

Studio Magazine 120/400
Top Load Adapter
Studio Magazine 300/1000
16 ARRICAM System Guide
Studio Magazine 120/400
The 120m/400ft displacement magazine is torque motor driven and
runs forward and reverse. Built-in controls include: electronic raw
stock counter, ASA setting and an ASA display.
The footage counter is switchable between meter and feet.
A loop protector is included.
Compatibility: Can be mounted on top or back of the ARRICAM
Studio (with Top Load Adapter, Back Load Adapter or Dual Port
Adapter) or on the back of the ARRICAM Lite (with Studio Mag to
Lite Camera Adapter).
K2.54015.0 Studio Magazine 120/400
Studio Magazine 300/1000
The 300m/1000ft displacement magazine is torque motor driven and
runs forward and reverse. Built-in controls include: mechanical raw stock
check, electronic raw stock counter, ASA setting and an ASA display.
The footage counter is switchable between meter and feet.
A loop protector is included.
Compatibility: Can be mounted on top or back of the ARRICAM Studio
(with Top Load Adapter, Back Load Adapter or Dual Port Adapter) or
on the back of the ARRICAM Lite (with Studio Mag to Lite Camera
Adapter). When mounted with Back Load Adapter on Studio camera it
interferes with the ARRIHEAD. Use the Dual Port Adapter instead.
Cannot be used on Lite camera with Universal Low Mode Set.
K2.54027.0 Studio Magazine 300/1000
T op Load Adapter
When this adapter is attached to the ARRICAM Studio camera, both
Studio magazines can be mounted on top of the camera. It is mounted
with six screws (use 3mm hex key).
Compatibility: Only for ARRICAM Studio.
Does not work on ARRICAM Lite or with Lite magazines.
The Lite or Lite Universal viewfinders can be used with the Top Load
Adapter, but the Lite Frameglow and the Lite IVS cannot, since they
interfere with the Top Load Adapter. Use the Back Load Adapter instead.
K2.54045.0 Top Load Adapter
Back Load Adapter
When this adapter is attached to the ARRICAM Studio camera, both
Studio magazines can be mounted on the back of the camera. This
adapter brings the Studio magazines in a truly vertical position for
Steadicam use. It is mounted with six screws (use 3mm hex key).
Compatibility: Only for ARRICAM Studio. Does not work on
ARRICAM Lite or with Lite magazines. If used with the Lite IVS, the
handle of the Back Load Adapter must be taken off, and the Studio
Center Handle should replace the Studio Camera Handle.
K2.54047.0 Back Load Adapter
Back Load Adapter
09 / 2003